Remove Primary HBA PCIe Card From Motherboard
d.
To clear a PCIe card fault, use the set command. For example, to clear a fault
on PCIe 2:
-> set /SYS/MB/RISER/PCIE2 clear_fault_action=true
Are you sure you want to clear /SYS/MB/RISER/PCIE2 (y/n)? y
Set 'clear_fault_action' to 'true'
Remove Primary HBA PCIe Card From Motherboard
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes removing the primary HBA PCIe card from Oracle Database Appliance
Version 1.
1.
Prepare the server node for service.
a.
Attach an antistatic wrist strap.
See “Performing Electrostatic Discharge and Antistatic Prevention
Measures” on page 146.
b.
Remove the server node from the system.
Power is removed from the server node when you remove it from the system. See
“Removing Server Nodes From the System Chassis” on page 147.
c.
Remove the server node top cover.
See “Removing the Server Node Top Cover” on page 149.
2.
Remove the primary PCIe card.
a.
Locate the internal PCIe card [1].
Appendix A • Servicing the Oracle Database Appliance Version 1 187
To Next Page
Loading...
Need help?
General