Oracle Database Appliance Version 1 Hot-Pluggable Components
If you have Oracle Database Appliance X7-2 series, go to “Oracle Database Appliance X7-2
Series Server Node Hot-Pluggable Components” on page 65. If you have Oracle Database
Appliance X6-2 series, go to “Oracle Database Appliance X6-2 Series Server Node Hot-
Pluggable Components” on page 71. If you have Oracle Database Appliance X3-2/X4-
2/X5-2, go to “Oracle Database Appliance X3-2/X4-2/X5-2 Server Node Hot-Pluggable
Components” on page 77.
Only certain versions of Oracle Database Appliance support a storage shelf (the Oracle
Database Appliance Version 1 does not). If you have Oracle Database Appliance that supports a
storage shelf and you need to service its components, go to “Oracle Database Appliance X3-2/
X4-2/X5-2 and X6-2-HA/X7-2-HA Storage Shelf Hot-Pluggable Components” on page 78.
Hot-pluggable components are those that can be removed and installed while the system and the
server nodes are running. These are designated as Customer Replaceable Units (CRUs).
In Oracle Database Appliance Version 1, the following devices are hot-pluggable:
■
Storage and Boot Drives. See “Servicing Storage Drives and Boot Drives
(CRU)” on page 152.
■
Fan modules. See “Servicing Fan Modules (CRU)” on page 159.
■
Power supplies. See “Servicing Power Supplies (CRU)” on page 163.
Note - After a physical insertion or removal action of a storage component (such as a disk or
SAS cable), you should wait before performing the next action to allow the system software to
fully process the event. This could take up to 3 minutes to complete.
Note - For the Oracle Database Appliance Version 1, you must run the oakcli add disk -
local command after replacing a failed disk. Refer to the Administration and Reference Guide
for details.
Chapter 3 • Servicing CRUs That Do Not Require System Power Off 99
To Next Page
Loading...
Need help?
General