Oracle SPARC T8-1 - Page 118

Replace the Battery
-> show /SP/clock usentpserver
Properties:
usentpserver = enabled
d.
If enabled, set the property to disabled.
-> set /SP/clock usentpserver=disabled
2.
Replace the battery.
Replacing the battery is a cold-service procedure. The server must be completely powered off
and power cables disconnected before performing this procedure.
a.
Prepare the server for service.
b.
If a PCIe card is in slot 6, remove it to improve access to the battery.
See “Remove a PCIe Card or Filler” on page 108.
c.
Remove the old battery
118 SPARC T8-1 Server Service Manual • January 2022