Launch a Serial Console Redirection Session
Accessing and Using System Administration Tools 27
■
Host storage device redirection: Mount an image file on the server service processor (SP)
and redirect that image to the host. Host storage device redirection is useful when installing
an operating system.
To launch a remote redirection session from Oracle ILOM, see the following procedures:
■
“Launch a Serial Console Redirection Session” on page 27
■
“Launch a Graphical Remote Console Redirection Session” on page 28
■
“Configure a Host Storage Device Redirection Session” on page 29
Launch a Serial Console Redirection Session
Use the Oracle ILOM command-line interface (CLI) to start or stop a serial console redirection
session. You can launch multiple redirection sessions to the host from the Oracle ILOM
command-line interface. However, only the first of all current serial console redirection sessions
is granted read and write privileges. All other logged-in sessions are read-only. Read and write
privileges are reassigned when a user with read and write privileges closes his or her session,
and a new serial session is opened.
Before you start a serial console redirection session, ensure that you have Console (c) role
privileges in Oracle ILOM.
1.
Log in to the Oracle ILOM command-line interface.
For instructions, see “Accessing Oracle ILOM” on page 21.
2.
Type start /HOST/console.
A confirmation prompt appears.
3.
Type y to confirm that you want to start a serial console redirection.
You are now viewing the host console.
4.
If you are prompted for user credentials, enter the requested information to
access the host server operating system.
You are now logged in to the host server operating system through the serial console.
Note - To enter standard Oracle ILOM CLI commands, you must first exit the host serial
console.
5.
To terminate the serial console redirection session, perform the following steps:
a.
Log out of the host server operating system.
b.
Press Escape + (.
To Next Page
Loading...
Need help?
General
