SPARE TIRE REMOVAL - Continued
NOTE
•
If air powered wrench is used, HET Tractor air system will be
depleted. Engine must be running to provide air to components. If air
powered wrench is used, do Steps (5) through (7). If not, go to Step
(8).
•
If engine is started during tire change, CTIS on/off switch must be in
the off position.
5. Remove air wrench (7) and air hose (8) from stowage box (9).
7
8
8 10
9
4
11
12
Figure 4.
6. Install air hose (8) in air supply coupling (10).
7. Install air hose (8) on air wrench (7).
TM 9-2320-360-10 0108
0108-6
To Next Page
Loading...
