Panasonic AWRP120

15
Registering PRESET SPEED on the unit
To register the PRESET SPEED value to a preset number of the unit,
perform the following steps after the previous procedure
5 Press the MEM STORE button to turn on its indicator
6 Hold down a number button to specify the preset
number to register
The current remote camera settings are registered to preset
memory, and PRESET SPEED is registered to the unit
 To continue registering a different PRESET SPEED value to a
preset memory belonging to the same “page number”, repeat
steps 3
→
4
→
6
Setting the PRESET SPEED recall mode
1 Press the MENU button to turn on its indicator
2 Open CAMERA SETUP menu [24]
3 Turn the F1 dial to display the “3 RECALL PST SPD”
item
3.RECA LL PST SPD
Off
4 Turn the F2 dial to select the recall mode, and then
press the F2 dial to confirm the selection
Off : Recalling preset memory moves the remote cameras at the
speed of the PRESET SPEED values set on the remote
cameras
On : Recalling preset memory moves the remote cameras at the
speed of the PRESET SPEED value registered for each
preset number on the unit
Operating preset memory (PMEM) (continued)