19
Operating tracing memory (TMEM) (continued)
6 Hold down one of the number buttons [1] to [10] that
has its indicator turned off to specify the tracing
memory number
The current camera position and settings are registered to the preset
memory of the remote camera, and become the start position and
settings at the time of recalling
The indicators of the number button that was held down and START
button [11] blink (Recording standby state)
If an operation that is target for recording such as moving the PAN/
TILT lever is performed at that time, the recording standby state is
canceled and the status returns to that of step 3
TM05:
Standb y Store
Tracing memory number
If you want to register tracing memory to a button whose
indicator is on, delete the registered tracing memory and then
register the new tracing memory
If a button with the same number as a registered preset
memory is held down, the saved preset memory will be
deleted as it will be overwritten
Notes
7 Press START button [11]
The indicator of START button [11] turns on (Operation wait state)
TM05:
Waitin g Opr.
8 Operate one of the PAN/TILT lever, ZOOM button,
FOCUS dial, IRIS dial, and white balance mode selection
buttons
The recording of tracing memory starts from the point in time that the
operation began
TM05:0 m02s
Storin g
...
Recording time
9 Press STOP button [12]
Recording stops and the tracing memory is saved
The registered number button turns on and the status returns to that
of step 3
When the possible recording time elapses, recording stops
automatically
At that time, operations up until the point in time that recording
stops are recorded
Recalling tracing memory (RECALL)
1 Press one of the camera selection buttons
[CAMERA SELECT/GROUP SELECT] to select the
remote camera to be operated
2 Press the TMEM button to turn on its indicator
The tracing memory status appears
The indicators of number buttons with registered tracing memory
turn on
CAM01: TMEM
3m50s Remained.
Selected camera number
Remaining possible recording time (max 5 m 00 s)
A button with no tracing memory registered does not turn on
even when it is a button with preset memory registered
Note
3 Press one of the number buttons that has its indicator
turned on to specify the tracing memory number
The remote camera moves to the start position
The indicators of the number button that was pressed and START
button [11] blink (Recall standby state)
TM03:0 m00s
/0m59s
Standb y Recall
4 Press START button [11]
The tracing memory is recalled and the remote camera starts
moving
The indicator of START button [11] turns on
TM03:0 m20s
/0m59s
Recall ing
...
Tracing memory number
Current recall
position
Total time of tracing
memory during recalling
5 When the recording time elapses, the remote camera
stops automatically
The number button that was blinking turns on, the indicator of
START button [11] turns off, and the process returns to step 2
Pressing the STOP button [12] or performing an operation that
is target for recording such as moving the PAN/TILT lever during
recalling will stop recalling and return the process to step 2
To Next Page
Loading...
