Panasonic AWRP120

36
Memory card operations
The unit allows you to use a memory card to perform the following
operations
SAVE : Save the configuration data of the unit or a remote camera to a
memory card
LOAD : Load the configuration data saved to a memory card to the unit
or a remote camera
<Data Target for SAVE and LOAD>
Data
type
Description of data File names *
1
SAVE/
LOAD
RPDAT
Configuration data of
unit *
2
RP01s12 to
RP99s12
SAVE and
LOAD
CAM
Configuration data stored
on the remote cameras *
3
RP01c12 to
RP99c12
SAVE and
LOAD
RPMEM
Memory related data
stored on the unit *
4
RP01m12 to
RP99m12
SAVE and
LOAD
UPG Unit version update file
V*****r5d to
V*****r5d
LOAD only
LOG Unit operation log
RP01log to
RP99log
SAVE only
*
1 : When SAVE is executed on the unit, the file names above are
assigned automatically
Also, after SAVE is executed on the unit, the file names can be
changed with a personal computer
 About file names
RPDAT: ********s12
CAM: ********c12
RPMEM: ********m12
Use “up to eight single‑byte alphanumeric characters” for the
******** part above A file name other than the above may not be
displayed properly on the unit
*
2 : The IP address, subnet mask, default gateway settings of the unit
and the user authentication settings (user name and password) are
not target for the SAVE and LOAD operations
*
3 : Only the following data for one selected remote camera is target for
SAVE and LOAD
 Settings of each shooting mode (scene file)
 Preset memory data
 System settings
*
4 : The following data is target for SAVE and LOAD
 Tracing memory data
All data of camera numbers CAM1 to CAM10
 PRESET SPEED
PRESET SPEED values set for all preset numbers of camera
numbers CAM1 to CAM100
 SAVE and LOAD are not possible with the CAM item of a camera
connected via a serial connection
 Preset memory data is not included in “RPMEM”
Therefore, when a different remote camera than the one when
SAVE was executed is connected, just loading “RPMEM” to the
unit will not result in the start position being recalled when the
tracing memory is recalled
When replacing a remote camera, also execute SAVE and LOAD
of “CAM”
Notes
Precautions on handling memory cards
 Never remove a memory card while the memory card access lamp
is lit or blinking
If you remove a memory card while the memory card access lamp
is lit or blinking, the data saved to the memory card may be lost
 The data stored in a memory card may be lost due to, for example,
the loss or incorrect operation of the memory card
We recommend saving any important data to a computer or other
device
 Memory cards
Memory cards used with the unit should conform to SD or SDHC
standards
Be sure to use the unit to format memory cards
Memory cards with the following capacity can be used with the
unit
SDXC memory cards and MultiMediaCards (MMC) are not
supported
SD 8 MB to 2 GB
SDHC 4 GB to 32 GB
For the latest information not described in the Operating
Instructions, refer to the following websites
http://pro‑avpanasonicnet/
 Observe the following points when using and storing the
memory cards
• Avoid high temperature and humidity
• Avoid water droplets
• Avoid static electricity