21
6 Press START button [11]
The tracing memory is recalled and the remote camera starts
moving
TM03:0 m20s
/0m50s
Restor ing
...
Current recall position
Total time of tracing memory
during recalling
7 Operate one of the PAN/TILT lever, ZOOM button,
FOCUS dial, IRIS dial, and white balance mode selection
buttons to make a correction
Overwriting is performed from the point in time that the correction
operation is performed
It is not possible to correct just an arbitrary section of
recorded tracing memory data
The registered data is deleted from the point in time that the
operation is performed so continue the operation until the
recording time ends to register the new data
Note
8 When the recording time elapses, the remote camera
stops automatically
The process returns to step 3
When STOP button [12] is pressed during recalling, recalling
stops
The total time of the tracing memory changes, and the process
returns to step 3
Setting the items to recall when recalling
tracing memory
You can select whether to recall all or only some of the items registered
to tracing memory
This function is enabled when AW‑HE50, AW‑HE60, or
AW‑HE120 is selected
Note
1 Press the MEM SETTING button
The current setting appears
SPEED : ———
SCOPE : MOD E A
If approximately 3 seconds elapses without an operation being
performed, the previous LCD panel display is redisplayed
2 Turn the F2 dial to select a setting for the “SCOPE” item
from MODE A to MODE C, and then press the F2 dial to
confirm the selection
The setting of the unit is changed
This is applied the next time the tracing memory is recalled
<SCOPE settings and recalled items>
Setting
Recalled item
Pan, tilt, zoom,
and focus
Iris
White balance
mode
MODE A √ √ √
MODE B √ √ —
MODE C √ — —
√: Recalled —: Not recalled
When the operation is performed, the PRESET SCOPE setting of
the remote camera is changed to the same setting as well at the
same time
⇒ “Setting the operation items for when preset memory is recalled
(PRESET SCOPE)” (page 14)
Operating tracing memory (TMEM) (continued)