Panasonic AWRP120

26
Controlling the peripheral devices
connected to a remote camera
The peripheral devices connected to a remote camera can be controlled
Control the devices with FUNCTION menu [23]
1 Press the MENU button
2 Open FUNCTION menu [23]
Controlling an AW‑PS300A AC adapter
When an AW‑PH360 is being controlled with the unit, you can control an
AW‑PS300A AC adapter via the AW‑PH360
 For details on how to connect the AW‑PH360 and AW‑PS300A, refer
to the Operating Instructions for each device

Controlling an option switch control output terminal
The short circuiting and open circuiting of the option switch control
output terminal [OPTION SW CONTROL OUT] of the AW‑PS300A can
be controlled
3 Turn the F1 dial to display the “1 OPTION” item
1.OPTI ON
Off
4 Turn the F2 dial to select “Off” or “On”, and then press
the F2 dial to confirm the selection
On : Short circuits the OPTION SW CONTROL OUT terminal
Off : Open circuits the OPTION SW CONTROL OUT terminal
 When AW‑HE60 is connected, you can switch between normal
shooting mode and night mode in the “1 OPTION” item
On : Sets night mode
Off : Sets normal shooting mode
When the mode is set to night mode, the shining of an infrared
light on the subject enables shooting under low illumination
which would normally make shooting difficult Furthermore, the
output video becomes black and white
Also refer to the Operating Instructions for the AW‑HE60
Note

Controlling the lamp AC outlet
The ON and OFF of the lamp AC outlet [LAMP AC OUT] of the
AW‑PS300A can be controlled
3 Turn the F1 dial to display the “5 LAMP” item
5.LAMP
Off
4 Turn the F2 dial to select “Off” or “On”, and then press
the F2 dial to confirm the selection
On : Enables the LAMP AC OUT connector
Off : Disables the LAMP AC OUT connector
Controlling a defroster
When the selected remote camera is equipped with a defroster function
(AW‑PH650 + camera), the defroster can be controlled
3 Turn the F1 dial to display the “2 DEFROSTER” item
4 Turn the F2 dial to select “Off” or “On”, and then press
the F2 dial to confirm the selection
2.DEFR OSTER
Off
Controlling a wiper
When the selected remote camera is equipped with a wiper function
(AW‑PH650 + camera), the wiper can be controlled
3 Turn the F1 dial to display the “3 WIPER” item
4 Turn the F2 dial to select “Off” or “On”, and then press
the F2 dial to confirm the selection
3.WIPE R
Off
Controlling a heater or fan
When the selected remote camera is equipped with a heater or fan
function (AW‑PH650 + camera), the heater or fan can be controlled
3 Turn the F1 dial to display the “4 HEATER/FAN” item
4 Turn the F2 dial to select “Off” or “On”, and then press
the F2 dial to confirm the selection
4.HEAT ER/FAN
Off
Configuring the remote camera operation settings (continued)