45
Setup Software
Setup Software is an application for configuring the settings for connecting the unit with the remote cameras and switcher from a personal computer
The settings can be configured while confirming each item in a list
The settings for connecting the unit with the remote cameras and switcher can also be configured using just the unit For how to configure the settings
on the unit, refer to “Settings for connecting with the remote cameras and switcher” in <Basics> (page 29)
When using Setup Software to configure the settings from a personal computer, observe the following
Do not perform any operation on the unit
Do not start Setup Software on any other computer in the same network
Do not use “Easy IP Setup Software” supplied with AW‑HE120, AW‑HE60, and AW‑HE50
Notes
Installing the software
This section describes how to install Setup Software
1 Insert the CD‑ROM supplied with the unit into the CD‑ROM drive of the personal computer on which the application is going to be installed
2 Copy the entire folder containing “Setup Software” on the CD‑ROM to the hard disk drive of the personal computer
3 Double‑click “RP120Toolexe” in the copied “Setup Software” folder to start Setup Software
Configuring the settings of the personal computer
Configure the following settings of the personal computer before connecting it to the unit
IP address : Set an IP address that is not a duplicate of the IP address set on the unit or any IP address set on the devices (remote
cameras, switcher, etc) connected within the same subnet
Subnet mask : Set the same subnet mask as that set on the unit
Default gateway : Set the same default gateway as that set on the unit
Confirm the IP address, subnet mask, and default gateway set on the unit in RP SETUP menu [25]
IP address : “7 IP ADDRESS” item
Subnet mask : “8 SUBNETMASK” item
Default gateway : “9 GATEWAY” item
To Next Page
Loading...
