Panasonic CF-18 Series

The Watcher Window
Rev 0.21 Dec.04 19
Some icons are subject to feature availability.
Call status area
The call status is shown in the central part of the Status box
while in Full view. Information about the current call is
provided as noted below:
Data calls
Subject to feature availability.
• “Ready to connect”
• “
Connecting”, and the connection name and phone number.
• “
Authenticating”
• “
Connecting to Internet” - the wireless device is acquiring an
IP address via DHCP.
• Once connected: duration of the connection, number of
bytes received (Rx), and transmitted (Tx).
Note: Even though the approximate number of bytes sent and
received is displayed while the connection is running, this is not
necessarily the actual amount of data being transmitted across the
network.
WiFi
Subject to feature availability.
• “Ready to connect”
• “
Connecting to” (hotspot name)
• “
Connected to” (hotspot name)
• “
Unable to connect to the Internet”
Voice calls
Subject to feature availability.
• “Ready to connect”
• The phone number as you are entering it
• “
Dialing” and the name (if available) and phone number of
the person you are calling; then, if you are using Link
Dialing, “
Link Dial Mode”
• For incoming calls:
· “
Voice Call From”, or, if you are roaming, “Roam Call
From
”
WiFi signal strength (displayed in the right part of the
connection status area)
An error has occurred; the device is not working
properly. If this icon persists, reset the device.