Data Services
Rev 0.21 Dec.04 31
Quick 2 Net
Subject to feature availability.
Note: You cannot establish a
data connection if a voice call is
active. You must first end the
voice call.
Quick 2 Net (QNC) uses a circuit switched method to connect
to the Internet. The connection is slower (maximum speed of
14.4 kbps) than a VZAccess (NationalAccess or Broadban-
dAccess) packet data connection.
Quick 2 Net can be used when you have CDMA coverage but
not VZAccess (NationalAccess
or BroadbandAccess )
service. This connection is treated like a standard phone call.
You can set the modem to automatically disconnect an idle
Quick 2 Net connection.
To make a Quick 2 Net connection:
1. Select the
Data tab of Watcher.
2. From the drop-down menu, select
“
Quick 2 NetSM (14.4kbps)”.
3. Click
Connect.
The connection progress is displayed in the Call status area.
Quick 2 Net calls connect faster than standard dial-up connec-
tions.
Related Topics:
>>| End a data session
>>| Default data profile
>>| Automatic data call disconnection
End a data session
To end a data session:
• From the
Data tab , select Disconnect (if connected) or
Cancel (during the connection process)
If Always-on connection is in use, manually disconnecting will
leave the EM5625 disconnected. It will not reconnect until one
of the following occurs:
• You make a VZAccess (NationalAccess or Broadban-
dAccess) high-speed packet data connection
• Watcher is restarted
Automatic data call disconnection
Subject to feature availability.
You can set Watcher to automatically disconnect dial-up and
Quick 2 Net data calls that have been inactive (no data trans-
mitted) for a specified period of time.
To Next Page
Loading...
