Panasonic CZ-256ESMC3 - Page 191

191
Conguring the Hybrid GHP/EHP control
Setting
“Delay time settings” screen
Note
y Of the outdoor units registered in the “O/D unit settings” screen (P.146), only those outdoor units that support Hybrid GHP/EHP
control are shown. Sub units are also shown, but the setting only affects main units.
A: Shows the circuit (Intelligent controller) that
the outdoor unit is connected to.
Currently this is xed to “IntelliCon”.
B: Select the linked system that the outdoor
unit is connected to.
C: The delay group setting content for each
time slot corresponding to outdoor units is
shown in graphs.
D: The “Delay group settings” screen is
displayed when you touch this.
E: When you touch this, you can make settings
for the delay groups for each outdoor unit
time slot with a check mark in the “Select”
column.
C
A
B
D E
Setting delay times [Delay time settings]