Panasonic CZ-256ESMC3 - Page 208

208
Maintenance settings
Setting
5
Put a check mark in the “Select” column.
z Select the outdoor units you want to run a test operation
for.
z You can select multiple outdoor units.
5
6
Touch [Oprn].
z The operation dialogue is displayed.
6
7
Select the operation mode ([Cool] or
[Heat]) (7-1) and touch [ON] (7-2).
z The settings are registered and the operation dialogue
closes.
z The test operation starts.
7-
1
7-
2
8
Check the “Stus” column.
z During the test operation, the operation mode is shown in
the “Stus” column ( for cooling and for heating).
9
To stop the test operation, touch [Oprn],
then touch [OFF] in the operation
dialogue.
Running a test operation