79
Settings for energy saving
Energy saving
The “Set temp. auto return” screen
A: [Select all]/[Clear all] buttons
[Select all] Select all indoor units.
[Clear all] Cancel selection of all
indoor units.
B: Change list order. The list order changes each
time you touch it.
Display The display follows the order set
in “I/D unit settings” (P.141).
O/D unit The display follows the outdoor
unit display order set in “O/D unit
settings” (P.145).
Address The display follows the address
order set in “I/D unit settings”
(P.141).
C: The indoor units with a check mark next to
them will be the subject of the changes to the
settings.
D: The temperature auto return setting is
enabled for the selected indoor unit if you
put a check mark here. This is linked with
the “Auto return” (“Setting” dialogue) (P.78)
setting.
E: The “Setting” dialogue is displayed when you touch this.
A
B
D
E
C
Automatically return to set temperatures [Set temp. auto return]
To Next Page
Loading...
