116
5. Feed 1 While pushing the “START/STOP Key” on the Control
Panel, turn on the scanner.
——
2 Release the key after LED (Back) status changes to
blinking.
OFF
Blinking
3
Push the “START/STOP Key” once to enter the test
selection mode.
Blinking
Count
4 Push the “START/STOP Key” once at the timing when
LED (Back) status is 5 (h)
*5
.
5 Set documents on the Feed Tray.
6 Push the “START/STOP Key” to feed documents.
7 Turn off the scanner to finish this test. — —
6. Shading 1 While pushing the “START/STOP Key” on the Control
Panel, turn on the scanner.
——
Before executing the
shading function, be
sure to clean the
Scanning Glass (F),
Scanning Glass (B),
Reference Plate (F),
Reference Plate (B),
rollers, and
conveyors related to
conveying
documents.
Until this process
is completed,
don’t stop the
process by
opening any doors
or turning off the
scanner.
2 Release the key after LED (Back) status changes to
blinking.
OFF
Blinking
3 Set the Shading Sheet (Part No.: See 14.8.) on the
Hopper in landscape orientation.
OFF
Blinking
4
Push the “START/STOP Key” once to enter the test
selection mode.
Blinking
Count
5 Push the “START/STOP Key” once at the timing when
LED (Back) status is 6 (h)
*6
.
6 Push the “START/STOP Key” for 5 seconds or more to
start shading.
7 When the Ready and Error Indicators start to blink,
reverse Reference Plates to white after opening the
ADF Door. And then close the ADF Door.
8 Paper feeding starts to execute the shading.
(At this time, the Error Indicator status changes from
blinking to OFF.)
9 When the Ready and Error Indicators start to blink
again, reverse Reference Plates to black after opening
the ADF Door. And then close the ADF Door.
10 After confirming the Ready Indicator turns ON and the
Error Indicator turn OFF, turn off the scanner to finish
this test.
—
To Next Page
Loading...
