Panasonic KV-S5046H - Main Cleaning Procedures

35
7.2.2. Cleaning-1 (Main)
Following the instructions in figures Fig.7.2.2-1, wipe dust from the surface of the following parts in order to maintain
high scanning performance.
Note:
After cleaning the Paper Feed Roller, Separation Roller, and Double-feed Prevention Roller, execute
“Clear Counter for cleaning roller” with Service Utility. (See 9.3.4.)
(Fig. 7.2.2-1) Cleaning Parts and Action
**Action Code means cleaning methods as follows.
C: Clean each surface with the included Roller Cleaning Paper or Model KV-SS03. (Option: Roller Cleaning Paper)
B: Clean up with the cotton swab.
Caution:
*1
• The Scanning Glass (F), Scanning Glass (B), and their surroundings may be hot after scanning a lot of documents
continuously. Be sure to allow the inside of the scanner to cool down before performing any maintenance
or coming in contact with the inside of the unit.
Note 1: Roller Cleaning Paper
• Open the bag on the dotted line and take out the Roller Cleaning Paper.
• If the bag is left open for a long period of time before using it, the alcohol will evaporate. Please use the Roller
Cleaning Paper immediately after opening the bag.
• The Roller Cleaning Paper (KV-SS03 Option) is available from sales channel.
Description
**
Action Code
Remarks
Paper Feed Roller C 1. After cleaning these three rollers, execute “Clear
Counter for cleaning roller” with Service Utility.
(See 9.3.4.)
2. Refer to Note 1 (Roller Cleaning Paper).
*2
Separation Roller
C
*2
Double-feed Prevention Roller
C
Drive Roller 1 C Refer to Note 1 (Roller Cleaning Paper).
Drive Roller 2 C
Drive Roller 3 C
Exit Roller C
Free Roller 1 C
Free Roller 2 C
Free Roller 3 C
*1
Scanning Glass (F)
C
*1
Scanning Glass (B)
C
Reference Plate (F) C, B Refer to Note 1 (Roller Cleaning Paper).
Refer to Note 2 (How to clean sensors (detectors)).
Reference Plate (B) C, B
Ionizer (Ion outlet) B 1. Refer to Note 2 (How to clean sensors (detectors)).
Reference Sheets for sensors B
Paper Sensor B
Waiting Sensor (on the USS / WAITING SENSOR
Board)
B
Starting Sensor (Board) B
Slit Detect Sensor (Board) B
Exit Sensor (on the ENDING SENSOR Board) B
Double Feed Detector (G) B
Double Feed Detector (R) B