Panasonic KV-S5046H - Bottom Block; CONTROL Board and DRIVE Board

50
8.2. Bottom Block
8.2.1. CONTROL Board and DRIVE Board
1. Remove the screw(a) and the 18 screws(b) that support
the Cover Plate on the bottom of the scanner.
Then, remove the Cover Plate.
2. Disconnect all connectors (9 connectors and 3 flat cables)
on the CONTROL Board.
3. Remove the 7 screws and 2 COATING CLIP on the
CONTROL Board.
Then, remove the CONTROL Board.
4. Disconnect all connectors (12 connectors and 2 flat cables)
on the DRIVE Board.
5. Remove the 7 screws on the DRIVE Board.
Then, remove the DRIVE Board.