80
8.5.14. Hopper Plate Assembly
1. Remove the Double-feed Prevention Roller. (See 8.5.13.)
2. Remove the Hopper Motor. (See 8.5.9.)
3. Remove 2 screws and release 3 claws and remove
Hopper Base cover.
4. While releasing the 3 claws on the bottom of Hopper Plate
Assembly and pushing down the top of the Gate, pull and
remove the assembly forward.
(1) While pull the Hopper Plate Assembly forward, release
the 3 claws (Claw1).
(2) While pull the Hopper Plate Assembly upward, release
the 2 hooks to remove the assembly.
5. Lift up the Hopper plate.
To Next Page
Loading...
