Panasonic KV-S5046H - Conveyor Bottom; DFP Pressure Motor; USR SENSOR Board

82
8.5.16. Conveyor bottom
8.5.17. USR SENSOR Board
8.5.18. DFP Pressure Motor
1. Remove the Hopper Plate. (See 8.5.14.)
2. Remove the 2 screws.
3. Remove the Conveyor bottom.
1. Remove the Conveyor bottom. (See 8.5.16.)
2. Remove the screw, and then disconnect the connector.
1. Remove the Left Cover. (See 8.5.10.)
2. Remove the Conveyor bottom. (See 8.5.16.)
3. Remove the USR SENSOR Board. (see 8.5.17.)
4. Remove the UL Tape.
5. Remove the connector from □ Hole.
6. Remove the screw(a) and 4 screws(b) on the Reinforcement
Plate.