Cleaning the Ion Outlets and Sensors
1. Remove dust from the ion outlets (A ) with a cotton swab.
• With a thin cotton swab, remove dust from the ion outlets, and then wipe the center of the inner parts
approximately 5 times.
(A)
Notice
• Do not apply too much pressure on the parts.
2. Remove dust from the sensors (A , B , C , D , E , F ) and reflectors (G ) with a cotton swab.
Location of Sensors
(A)
(C)
(D)
(E)
(B)
(B)
(F)
A Waiting sensor
B Double feed detector
C Slip detect sensor
D Starting sensor
E Paper sensor
F Skew sensor
To Next Page
Loading...
