13
4.3. Installing Double-feed Prevention Roller
1. Remove all packing tape.
2. Push the ADF Door Release (1) upwards, and open
the ADF door (2).
3. Use the indents (1) to pull the double feed prevention
roller cover towards you to open it.
4. Install the Double-feed Prevention Roller.
• Align the shaft that is shaped as indicated by (1) with the notch
in the roller mount (2), and then insert the shaft in the notch.
Push the shaft on the opposite side (3) until it clicks into place.
Note
After you install the Double-feed Prevention Roller, make sure
that the shaft is inserted into the tab, and that the shaft will not
rotate or move. If the roller is not installed correctly, it may
cause double feeding or a paper jam.
To Next Page
Loading...
