Panasonic KV-S5046H - Page 99

99
Note
*1
: This item is available only if the optional Imprinter is installed to the scanner.
*2
: These items are also available in User Utility software.
*3
: This setting is needed when replacing CONTROL Board or IC0004.
Remarks
1. Parameter setting by user
2. Status indication
3. Parameter setting by service person
4. Adjustment
5. Diagnosis
6. Maintenance
Adjust Shading Used to execute shading correction 4
All Position Used to adjust scanning length, paper end position, width,
vertical position, and horizontal position adjustment for front and
back sides automatically
4
Individual Position 1. Used to execute automatic length, paper end position, width,
vertical position, or horizontal position adjustment for front and
back sides, individually
2. Used to adjust scanning length, paper end position, width,
vertical position, or horizontal position for front and back sides
manually
4
Double Feed Used to correct the Double Feed Detector’s ultrasonic emission
level automatically
4
Bent Paper Sensor Used to correct the Bent Paper Sensor’s sending level
automatically
4
USB ID
*3
Used to set a USB ID for the scanner, connected to the PC 3
Feed Speed Used to change the paper feed speed 3
Sensor Sensitive Level Used to check the status (Offset level, Slice level, LED current) of
each Sensor
(Waiting, Slip Detect, Starting, Exit)
Other
Save Information
*2
Used to save the scanner and PC information 1
Item Purpose Remarks