Panasonic SD-PM107 - In Case of the Following Displays

EN46
Display
電源中斷
•Notifiesyouofpowerfailureduringoperations.
Ifpowerfailsforlessthan10minutes,theoperationswillresumewhen
power supply resumes.
(Unsuccessful bread-making may occur sometimes)
•Itwillstilldisplaywhenthepowerplugispluggedinafteritisremoved.
Display
•Theoventemperatureriseshighdue
tocontinuoususe.(above40°C)
Open the lid to reduce heat
inside of the main unit fully.
(Cooldownforabout1hourafter
baking is finished)
Display
~
•Failure
•
Please contact with Panasonic service centre for repair.
In case of the following displays
When the following
conditions happen
Causes Solutions
Abnormal sounds
on the blade
•Thereisaclearancebetweenthebladeandtheshaft.
(Thefrontendmovesby3cmorso.)
Plug into the
outlet, the current
time on display is
"0:00"
•Thelithiumbatteryisattheendofitsworkinglife.
•
 Beforereplacementofbattery,operationscanbe
continued with power plug inserted.
•
 Setthecurrenttimewheneveryouusethetimer
functions.
Please send to the service centre
for professional maintenance staff
to replace the battery.
Powders still
remain and baking
does not occur
•Haveyouforgottentoinstalltheblade? Install the blade. (P. EN12)
•Isthebladeshaftexcessivelyfastenedinthe
breadpansothatitcannotmove.
Please replace the main shaft
bearing if the blade shaft does not
rotate.
Please consult your Panasonic
customerservicecentre.
Dough is leaking
out at the bottom
of the bread pan
•Asmallamountofdoughleaksoutfrom
the discharge port of the bread pan during
operations.
Toavoidaffectingthe
rotations, the dough that
enters the rotational part
will be discharged.
Thisisnormal.
Please confirm if the
blade is rotating.
The bottom of the
bread pan turns
black
•Thebottomofthebreadpanmayturnblackduetofrictionswhenkneading.
In that case, please wipe and clean with a damp kitchen towel.
•Smokesorodorsmayoccuruponinitialuse.However,theywilldisappearsometimeafteruse.Operationsarenot
affected.
Shaft
Troubleshooting
Discharge port
(4positions)
At the bottom of
the bread pan
( )
( )
( )
Please confirm the following issues first.
If any anomaly is still identified, please contact Panasonic customer
service centre immediately.
SD-PM107_P36-47.indd 46 3/5/2018 20:12:16