Panasonic WV-SW355 - Page 34

34
34 35
[Frame rate*]
Select the frame rate for images to be recorded from
the following.
1fps/ 3fps/ 5fps*/ 7.5fps*/ 10fps*/ 12 fps (PAL model)*/
15fps*/ 20fps*/ 30fps*
Default: 30fps*
Note:
 • When"Framerate"isselectedfor"Recordingprior-
ity", this setting is available.
 • "Framerate*"isrestrictedby"Max.bitrate".For
this reason, the frame rate may be lower than the
specified value when any value marked with an
asterisk (*) is selected.
[Max bit rate]
Select the bit rate for images to be recorded from the
following.
64kbps/ 128kbps/ 256kbps/ 384kbps/ 512kbps/
768kbps/ 1024kbps/ 1536kbps/ 2048kbps/ 3072kbps/
4096kbps
Default: 1536kbps
[Image quality]
Select the quality for H.264 images to be recorded from
the following.
Low(Motion priority)/ Normal/ Fine(Image quality prior-
ity)
Default: Normal
Note:
 • When"Constantbitrate"isselectedfor"Recording
priority", this setting is available.
[Refresh interval]
Select an interval (I-frame interval; 0.2 - 1 second) to
refresh the H.264 images to be recorded from the fol-
lowing.
0.2s/ 0.25s/ 0.33s/ 0.5s/ 1s
Default: 1s
■ SD memory card information
[Remaining capacity]
Total capacity and remaining capacity of the SD mem-
ory card will be displayed.
Depending on the status of the SD memory card, the
size indications will differ as follows.
Indication Description
--------KB/--------KB No SD memory card is insert-
ed. Failed to obtain available
capacity due to error, etc.
********KB/********KB The SD card memory is unfor-
matted, or locked, etc.
Note:
 • When"Off"isselectedfor"Overwrite"andtheavail-
able size of the SD memory card has reached "0
KB",imageswillnotbesavedontheSDmemory
card. When the notification function is on, a notifica-
tion mail will be sent to the registered addresses
when the SD memory card becomes full. (☞ Pages
73 and 74)
[Format]
To format the SD memory card, click the [Execute] but-
ton.
Important:
 • BeforeformattingtheSDmemorycard,itisneces-
sary to select "Use" for "SD memory card" on the
[SD memory card] tab of the "Basic" page (☞ page
31)and"Off"for"FTPperiodicimagetransmission"
on the [FTP img. trans.] tab of the "Network" page
(☞ page 107).
 • UsetheSDmemorycardafterformattingitusing
the [SD memory card] tab. If using the SD memory
card that has not been formatted on the [SD mem-
ory card] tab, the following functions may not work
correctly.
 • Save/obtainimagesthatfailedtotransmittothe
FTP server using the FTP periodic image trans-
mission function
 • Save/obtainalarmimages
 • Save/obtainimagessavedmanually
 • Save/obtainimagesinaccordancewiththe
schedule settings
 • Save/obtainthealarmlogs,themanual/schedule
logs, the FTP error logs and the system logs