PAX S80 - Page 144

Chapter 6
How to Setup the POS terminal
NOTE: This document is CONFIDENTIAL and must be used exclusively for the operation of PAX programs. It may not be
duplicated, published, or disclosed without prior written permission from PAX.
. 137
Clerk/Server ID Mode, Continued
STEP
ACTION
DISPLAY
4.
The default setting is OFF.
Press [1] to disable Clerk ID mode.
OR
Press [2] to enable Clerk ID Mode.
5.
Enter the first clerk number/name designation to be
saved then press [ENTER]. (System defaults to
clerk number 1).
6.
Enter the clerk name using the same method as
editing the header information (maximum 19
characters). Press [ENTER] when name is
complete.
7.
When all of the clerk names have been entered,
press [CANCEL] to accept the entered names.
8.
Stop.
____________________
ENTER CLERK ID:
1
____________________
ID #1 Name:
ID#32 Name :
Clerk ID Mode: 1
1. OFF
2. ON