PAX S80 - No Paper Mode

Chapter 6
How to Setup the POS terminal
NOTE: This document is CONFIDENTIAL and must be used exclusively for the operation of PAX programs. It may not be
duplicated, published, or disclosed without prior written permission from PAX.
. 146
6.5.1 No Paper Mode
Note
This function enables or disables the printer or sets NPM to automatic.
When disabled, the terminal will not print a receipt for any transaction
and reports are not accessible. When set to AUTO, the terminal
automatically puts itself in NPM when it runs out of paper. When NPM is
enabled, the idle screen is flashing NPM instead of arrow.
Example #1: I need to process a few Forced transactions and I don’t
need receipts for them so I will put the terminal in No Paper Mode. This
way I will not waste any paper.
Example #2: The screen is flashing NPM. This means that the terminal
is in No Paper Mode. I will replace the paper if necessary and disable
NPM.
STEP
ACTION
DISPLAY
1.
From the Operation Settings menu, press [1] to
access No Paper mode.
2.
Input the Password and press [ENTER]
3.
Use the [▲] & [▼] keys to your selection and then
press [ENTER].
OR, Press the number corresponding with your
selection.
4.
Press [ENTER] to complete
OR
Press [CANCEL] to abort
5.
Stop.
ENTER PASSWORD:
NoPaper Mode: 3
1. OFF
2. ON
3. AUTO
ARE YOU SURE?
ENTR=YES, CANC=NO
OPER. SETTINGS:
1. No-Paper Mode
2. Buzzer Setup
3. Operation Mode
4. Battery Saver