PAX S80 - Post Auth

Chapter 6
How to Setup the POS terminal
NOTE: This document is CONFIDENTIAL and must be used exclusively for the operation of PAX programs. It may not be
duplicated, published, or disclosed without prior written permission from PAX.
. 191
6.7.6.2 Post Auth
Note
The Post Auth Transaction sub-menu under Edit Database is an easy
way for completion transactions.
Example: I need to complete transactions 1 through 14. This can be
done quickly by using the Edit Database function.
If it is not necessary to have a Completion Receipt for all of the
transactions, put the terminal in No Paper Mode. Remember to disable
NPM after all of the transactions have been completed.
STEP
ACTION
DISPLAY
1.
From the System Settings menu, press [5] for Edit
Database.
2.
Input the Password and Press [ENTER].
3.
Press [2] for Post Auth transactions.
4.
When Post Auth is not support or is disabled.
Else go next step.
5.
Input the transaction # to be completed.
6.
View the transaction on the display to verify it is the
correct transaction then Press [ENTER]
SYSTEM OPTIONS:
3. Working Mode
4. Test Mode
5. Pre-Dial Call
6. Database
EDIT DATABASE:
1. Void
2. Post Auth
3. Clear Database
4. Clear Reversal
ENTER PASSWORD:
____________________
Enter Trans #:
12
______________________
#0001 AUTH
AMT: 52.00
************4996
NOT AVAILABLE