PAX S80 - Batch Number

Chapter 6
How to Setup the POS terminal
NOTE: This document is CONFIDENTIAL and must be used exclusively for the operation of PAX programs. It may not be
duplicated, published, or disclosed without prior written permission from PAX.
. 172
6.7.2 Batch Number
Note
This menu option allows the batch number to be changed. Not all Host
processors use batch numbers so care should be taken when
accessing this function. Verify the current or last closed batch number
with the Host Processor before changing.
STEP
ACTION
DISPLAY
1.
From the System Settings menu press [2] to set
batch number.
2.
Input the Password and press [ENTER]
3.
Select the EDC host.
Note: If the Host is MPSTC, it will display MPSTC.
4.
Terminal displays the current batch No.
Input the New Batch # and press [ENTER]
5.
Press [ENTER] to complete
OR
Press [CANCEL] to cancel
6.
Stop.
ENTER PASSWORD:
SYSTEM OPTIONS:
1. Date/Time Setup
2. Batch Number
3. Working Mode
4. Pre-Dial Call
_____________________
New Batch No:
1
ARE YOU SURE?
ENTR=YES, CANC=NO
SELECT HOST:
1. MPSHC
2. MPSGC