PAX S80 - Page 27

Chapter 4
How to Do Transaction
NOTE: This document is CONFIDENTIAL and must be used exclusively for the operation of PAX programs. It may not be
duplicated, published, or disclosed without prior written permission from PAX.
. 20
6.
This prompt occurs when the Table Mode feature
is turned on.
When prompted, enter the table number then press
[ENTER].
7.
This prompt occurs when the Guest No. Mode
feature is turned on.
When prompted, enter the number of guests then
press [ENTER].
8.
If the account number was manually entered, the terminal will ask if the card
is present. Depending on the user’s response the terminal will prompt for
V-code and other AVS settings*.
* Dependent upon Fraud Control settings.
9.
Press [1] if the card is present.
OR
Press [2] if the card is not present.
10.
Enter the V-code from the back of the credit card
then press [ENTER].
11.
Enter the street address then press [ENTER].
i.e.: If billing address is 123 Main St., enter 123.
12.
Enter the ZIP Code then press [ENTER].
i.e.: If billing address ZIP code is 12345-0123., enter 12345.
13.
The terminal will contact the Host Processor for an approval and print one
receipt.
_________________
Enter Zip Code:
_________________
_________________
___________________
Street Address:
___________________
_________________
ENTER CVV2:
_________________
IS CARD PRESENT?
1. Yes
2. No
___________________
ENTER TABLE NO:
___________________
___________________
NUMBER OF GUESTS
___________________