SGM700 Digitizer
First use of indicator -continue-
First use by using PI Mach II software -continue-
SGM750 (Serial):
Here you can set (for both RS232 and RS422):
Protocol: Set the Protocol that is used on the serial port. Options are: None,
Printerm ASCII, NPV Slave, Mudbus RTU, Modbus ASCII.
Address: set the address of the SGM750 on the communication bus.
Stopbits: set the stopbits of the SGM750 on the communication bus.
Paritiy: set the parity of the SGM750 on the communication bus. Options are:
None, Odd, Even, Mark, Space.
Baudrate: set the speed cummunication of the SGM750. Options are: 1200,
2400, 4800, 9600, 19200, 38400, 57600, 115200.
Indicator: Set the Indicator that is sent out over the communication bus.
27
To Next Page
Loading...
