SGM700 Digitizer
Configuration Menu -dAC- -continue-
The following screen will be vissable:
In dAC 6 you set the weigher end value for the analog output. At this value the
analog output stops with its maximum value. Press key 2 < 2sec. to enter dAC 6.
Fill in the wanted end value using key 1 and
key 2. Key 1 is for changing the number (1-9), key 2 is for changing the position
of the cursor. Confirm by pressing key 3 >2 sec.
Increase Decrease Left
Right Confirm
The following screen will be vissable:
In dAC 7 you set analog output mode. Press key 2 < 2sec. to enter dAC 7. Scroll
thru the weigher function options pressing key 1 and select which analog output
mode is needed by pressing key 3 >2sec. (options are: 1-5).
Increase Decrease Confirm
39
To Next Page
Loading...
