PENKO SGM710 - Page 73

SGM700 Digitizer
Configuration Menu -FIL- -continue-
In FIL 4 you can set the number of the indicator shown in the display. Choose a
number between 1 and 19. When using the FIL parameters use 4, 5, 12 or 13.
The following screen is visible:
The options are:
For further detais on
the weigher functions check appendix I
Use key 1 and 2 to change the value. Key 1 is for changing the number
(1-9), key 2 is for changing the position of the cursor. Confirm by pressing
key 3 for >2 sec.
Up Down
Left Right Confirm
The following screen is
visible:
73
1 Weigher 10 Weigher x 10
2 Fast gross 11 Fast gross x 10
3 Fast net 12 Fast Net x 10
4 Display Gross 13 Display Gross x 10
5 Display Net 14 Display Net x 10
6 Tare 15 Tare x 10
7 Peak 16 Peak x 10
8 Valley 17 Valley x 10
9 Hold 18 Hold x 10
19 Signal