SGM700 Digitizer
Configuration Menu -CAL- -continue-
Use key 1 <2 sec. to toggle between the actual weight and the actual weight x10.
Use key 2 <2 sec. to toggle between the actual weight and the ADC value.
When finished press key 3< 2 sec.
The following screen is visible:
Use CAL 3 to check and delete all existing cali-
bration points.
Press key 2 <2 sec. to enter CAL 3.
The following screen is visible:
Step through the calibration points with key 1. Delete a calibration point by
pressing key 3 >3 sec.
Up Down Delete
During deletions, the following screen is visible:
82
To Next Page
Loading...
