SGM700 Digitizer
Configuration Menu -gCL- -continue-
Up Down Left Right Confirm
The following screen is visible:
In gcL 2 you can set the origin elevation of the
loadcell. This is the geographic elevation of where the loadcell is manufactured.
Press key 2 <2 sec. to set the origin elevation.
The following screen is visible:
Use key 1 and key 2 to enter the origin elavation of
the loadcell(s). Key 1 is used for changing the number (1-9), key 2 is used for
changing the position of the
cursor. And press key 3 >2 sec.to set the origin elevation. Choose value
between –1000 and 30000 meter.
Up Down
Left Right Confirm
The following screen is visible:
90
To Next Page
Loading...
