SGM700 Digitizer
Configuration Menu -gCL- -continue-
In gcL 3 you can set the location latiude of the loadcell(s). This is the
geographic latitude of where the loadcell is going to be used. Press key 2 <2 sec.
to set the location latitude.
The following screen is visible:
Use key 1 and key 2 to enter the location latitude of
the loadcell(s). Key 1 is used for changing the number (1-9), key 2 is used for
changing the position of the
cursor. And press key 3 >2 sec.to set the location latitude. Choose value
be- tween –
90,00 and 90,00°
Up Down Left Right Confirm
The following screen is visible:
In gcL 4 you can set the location elevation of the loadcell. This is the
geographic elevation of where the loadcell is going to be used. Press key 2 <2
sec. to set the location elevation.
The following screen is visible:
91
To Next Page
Loading...
