215
7
Appendix
The subject is not
in focus.
The subject is difficult
to focus on with
autofocus.
Lock the focus on an object the same
distance away as the subject (by
pressing and holding the shutter release
button halfway), then aim the camera at
your subject and press the shutter
release button fully (p.56). Or set the
focus manually (p.90).
The subject is not in
the focusing area.
Locate the desired subject in the focus
frame (focusing area) in the center of the
display. If it is difficult to do so, first lock
the focus on the desired subject (focus
lock), and then move the camera to
recompose. Or, use the Z (Select) mode
to take a picture with the focusing area
set on the subject you wish to focus on
(p.93).
The flash does not
discharge.
The flash is not
popped up.
Pop up the flash.
The flash mode is set
to a.
Set to C (Auto) or b (Flash On) (p.84).
The drive mode is set
to j, A, C or l.
The focus mode is set
to s.
The shooting mode is
set to S, c, C or d.
The flash does not discharge in these
modes.
The flash mode
cannot be set.
The flash is not
popped up.
Pop up the flash.
Very occasionally, static electricity may cause camera malfunction. In
this case, remove the batteies and install them again. If the camera is
then working properly, normal condition is restored and you can continue
using the camera.
Problem Cause Remedy
To Next Page
Loading...
Need help?
General
