73
2
Taking Pictures
In a mode, press the A button to
select the setting (shutter speed or aperture
value) to be changed with the e-dial, and
then turn the e-dial to change the setting.
e
The shutter speed and aperture
value are changed so that the
exposure amount is maintained
(Program Shift).
b Shutter speed
c Aperture value
a Shutter speed and aperture value
•In a mode, EV Compensation is not available.
• [AUTO] cannot be selected for sensitivity.
• Flash modes C (Auto) and D (Auto + Red-eye) are not available.
•In a mode, the shutter speed and aperture value are adjusted for the
optimum exposure when you press the d/i button.
• A warning appears if there is a large difference between the current
exposure and the proper exposure. If the difference is greater than
±2.0EV, only the exposure warning icon is displayed. If the difference
is ±2.0EV or less, the exposure warning icon is displayed and the
difference between the current exposure and the proper exposure is
shown in increments of 1/3EV.
• When the shutter speed is set to a speed slower than 1 second, a
process to reduce image roughness and unevenness (Noise
Reduction) is performed.
• Even when the zoom ratio is changed, the aperture value is
maintained. However, when the current aperture value cannot be used
with the selected zoom ratio, the closest aperture value is set. In this
case, if you change the zoom ratio again and the original aperture
value can be used, the setting returns to the original aperture value.
To Next Page
Loading...
Need help?
General
