Pentax OPTIO VS20 - Page 108

106
3
Taking Pictures
6 Press the 3 button.
The camera returns to capture status.
Refer to the section “To Set the White Balance Manually” for
instructions on adjusting the white balance manually.
Have a blank sheet of white paper or similar material ready.
1 In the [White Balance] screen, use the four-way
controller (23) to select K (Manual).
2 Point the camera at the blank
sheet of paper or other material so
that it fills the frame displayed in
the center of the screen.
3 Press the shutter release button fully.
The white balance is automatically adjusted.
4 Press the 4 button.
The setting is saved and the [ A Rec. Mode] menu reappears.
5 Press the 3 button.
The camera returns to capture status.
Saving the White Balance setting 1p.128
To Set the White Balance Manually
MENU
Adjust
SHUTTER
White Balance
Cancel
C a n c e l
OK
O K
OKCancel
OK