Set-up
23
9 Set-up
Observe and comply with all regulations and instructions in this instruction
manual. Pay particular attention to all safety regulations!
All set-up work may only be carried out by appropriately instructed personnel.
Before starting welding, the transport roller and cutting wheel must be installed!
9.01 Initialization of the lifting drive (roller init)
With this function, the machine automatically determines the relevant positions
of the upper transport roller and the cutting wheel (if installed). To do this, the
upper transport roller traverses the entire travel path of the lifting drive several
times in order to determine the position and force deflection of the sonotrode
depending on the installed upper transport roller. It is imperative that there is no
material between the rollers.
The function is required:
- After changing the upper transport roller
- After a software update
- After a reset to the delivery status
- When the battery is weak
see chapter 11 Input
To Next Page
Loading...