Sealing
27
10.02.01 Motorised puller on/off
The motorised puller with pneumatic lifting cylinder is activated with the enable puller = 1
parameter
Puller Off
Puller On
This displays the puller key , which can be used to engage and lower the auxiliary drive .
If it is no longer needed, it can be switched off again and moved back to the standby position
with the key .
The link roller puller = 0..2 parameter can be used to link the puller with the roller position of
the top roller:
Link roller puller = 0 – no linkage, puller on and lowered, puller off and in the upper
position.
Link roller puller = 1 – puller closes only when the top roller closes, puller remains
closed when the top roller moves to the intermediate position,
puller opens when the top roller opens fully.
Puller off and in the upper position.
Link roller puller = 2 – puller closes when the top roller closes, puller opens when the
top roller moves to the intermediate position or opens fully.
Puller off and in the upper position
To Next Page
Loading...