PFAFF silberblau 8311 - Other Messages (Explanatory Texts)

Adjustment
88
E2: 2nd error byte
Bit position error text
0 Error: Monitoring min time
1 error: monitoring max time
2 errors: monitoring min energy
3 errors: monitoring max energy
4 Error: Monitoring min power
5 Error: Monitoring max power
6 Error: Overload
7 Error: transformer temperature
E3: 3rd error byte
Bit position error text
0 Error: Impedance oscillating
structure
1 error: watchdog expired
2 errors: output stage defective
E4: 4th error byte always = 00
16001
TIMEOUT STEPPER MOTOR
(DUAL)
Error in the DUAL Cut &
Seal stepper motor
Troubleshoot
3001
NO FILE SELECTED Operator error PAK
MANAGER
Troubleshoot
3002
WRONG MACHINE CLASS Wrong machine class
(PAK Manager)
Troubleshoot
3004
WRONG VERSION Wrong program version
(PAK Manager)
Troubleshoot
3005
CHECKSUM ERROR PAK Manager data error Troubleshoot
3006
MISSING DATA PAK Manager data error Troubleshoot
3007
MDAT IS NOT USABLE FOR THIS
MACHINE
MDAT can only be read
back on the machine
that saved this MDAT
Troubleshoot
Error number Display text Description Response
13.04.04 Other messages (explanatory texts)
Display text Description Response
NEW OPERATING SOFWARE
(RESET TO FACTORY SETTING)
Cold start after software
update
Troubleshoot
RESET TO FACTORY SETTING Cold start with (wire) jumper
X10 PIN1-PIN3
Troubleshoot
PLEASE REMOVE X10 1 < - > 3
(ENABLE FACTORY SETTING)
Remove cold start (wire)
jumper X10 PIN1-PIN3
Troubleshoot
CRC-CHECKSUM-ERROR
RESET TO FACTORY SETTINGS
Cold start because of data
errors in the battery-backed
memory (possibly check the
3.3 V battery)
Troubleshoot
POWERFAIL (OR SHORT-CIRCUIT) Power failure (or short circuit) Turn off