Sealing
31
10.02.05 Feed roller speed
The feed roller speed for the bottom and top feed rollers can be entered together by
pressing the feed roller speed touch field on the manual welding screen. A new input screen
will open for this purpose.
The feed roller speed can also be changed directly with the / keys.
The maximum feed roller speed is dependent on the gear assembly and roller
diameter used. The roller configuration "CONFIG" can be set in chapter 11 Input
Other parameters key.
Start inhibitor
The start inhibitor is the holdoff time between switching on the ultrasound and starting the
rollers. It is required to feed the energy into the material between the rollers before the
rollers start.
To Next Page
Loading...