Adjustment
96
13.12 Resetting to factory setting
The sealing parameter sets, settings and parameters for the 8303i are stored in a special
battery-buffered module. The data is therefore retained when the machine is switched off.
Sometimes it may be useful to reset this data back to the factory setting.
A simple example is, for example, the function to protect the sealing parameters
with
a PIN. If a changed PIN is forgotten, it can be reset again to the initial value 0000 with the
"Reset to factory setting" function
To do this, insert one or more wire jumpers on the spare terminal X10 when the machine
is switched on and the control box is open (observe the safety regulations), switch on the
machine and remove the plug-in terminal upon request. This triggers the following functions:
Note:
The function 2) No (wire) jumper is automatically carried out after a software update.
The function 2) is recommended after replacing the control unit.
To Next Page
Loading...