Sealing
38
Note:
Programs with only one section can be converted. Programs consisting of multiple linked
sections cannot be converted. They must first be deleted with the program editor except for
one section and only then can they be converted.
Program consists of multiple sections and can therefore not be converted. This prevents
programs from being inadvertently fragmented and therefore rendered unusable. Further
information can be found later in the
Programming chapter.
The key is used to execute the program selection.
Note:
A selected welding parameter set is activated and is therefore no longer available for
program links (see chapter Programming).
Note:
With the input / setting function, the entire welding parameter data record structure
can be displayed and data records can be reset.
This key is used to switch to the input function. The interrupted welding process is not
affected by this for the time being.
To Next Page
Loading...