Input
71
Machines with DUAL Cut & Seal equipment then determine the cutting wheel positions for cutting
forces up to 150N. For this purpose, the now relative sonotrode position is first determined. The up-
per roller moves with the cutting wheel in the upper switch-off position directly over the sonotrode
(position with zero Newtons). The cutting wheel then moves downwards in 0.05mm steps until it
touches the sonotrode and thus generates a force. This determines the relative stepper motor posi-
tion of the sonotrode.
In the next step, the stepper motor moves down with a higher resolution and saves the step-
per motor positions for the cutting forces up to 105N. The measured forces are displayed on the
screen.
After the cutting forces up to 100N have been recorded, the upper roller moves to the intermediate
position.
Now, in a third step, the determined cutting forces are extrapolated to 150N in 10N steps.
This completes the initialization. The display changes back to the settings page.
If the initialization cannot be carried out due to various errors, it must be repeated after the cause of
the error has been eliminated.
Possible error causes:
To Next Page
Loading...