Packaging
When sending the detector to a service center, keep the accessories delivered with the detector. Do not
return them with the product.
►
Proceed in reverse order of unpacking.
3.3 Handling
WARNING
Risk of crushing during product handling
Given the weight of the product, there is a risk of crushing during handling operations. Under no cir-
cumstances shall the manufacturer be liable if the following instructions are not followed:
►
Only qualified staff trained in handling heavy objects are authorized to handle the product.
►
The lifting devices provided must be used for the product and the procedures set out in this
document must be followed.
WARNING
Risk of serious injury due to falling objects
When transporting parts/components and during product maintenance, there is a danger of injury
caused by loads slipping or falling.
►
Carry small and medium-size components with both hands.
►
Transport components that weigh more than 20 kg using suitable lifting gear.
►
Wear safety shoes with steel toes in accordance with directive EN 347.
NOTICE
Damage to the equipment if a detector is handled while switched on
When switched off (main switch/circuit breaker at O), some components remain temporarily switched
on. There is a risk of electric shock in case of contact.
If it is necessary to move or work on the product, the user must first make sure that the detector is
fully shut down. There is a risk of damage to some of the detector’s components.
►
Make sure that the mains connection is always visible and accessible so that it can be unplugged
at any time.
►
Unplug the power cable.
►
Wait 5 minutes after power-off before working on the product.
A cart has been specially designed to handle the leak detector (see chapters “Accessories” and “Trans-
port”).
1 Handle
►
To move the product, 2 people should grasp it by the handle, or a lifting device should be used
(see chapter "Unpacking/Packing").
Transportation and Storage
15/98
To Next Page
Loading...
