3.4 Transport
WARNING
Risk of crushing related to product tilting
Although the product fully complies with the EEC safety regulations, there is a risk of tilting when it is
moved over the floor or is not properly secured or used.
►
Do not place the product on a plane with an incline greater than 3° (or 6%): its weight could
cause the operator to be dragged.
►
Place the product on a flat, hard floor.
►
Use the wheels to move the product.
►
Do not push the product sideways.
►
Do not press on the sides of the product.
►
Do not leave anything pressing against the product.
NOTICE
Damage to the equipment if a detector is handled while switched on
If it is necessary to move or work on the product, the user must first make sure that the detector is
fully shut down, otherwise there is a risk of damage to some of the detector components. When the
main switch/circuit breaker is set to O:
►
Unplug the power cable.
►
Wait for the control panel screen to turn off completely before working on the product and/or re-
moving the cover(s).
►
Wait 5 minutes after power-off before working on the product.
Transport case
We recommend that you use the transport case that was specially designed for the ASM 310 (see “Ac-
cessories” chapter).
Accessories can be stored in the foam of the case.
Transport cart
The transport cart makes it easier to move the detector (see “Accessories” chapter).
Maximum permitted weight on the transport cart: 26 kg
Transportation and Storage
16/98
To Next Page
Loading...
