For quick access from the main screen, use the [AUDIO] function key.
To quickly turn off the sound of the detector and the sniffer probe, use the [MUTE] function
key.
The red cross on the pictogram indicates that the "Mute" function is enabled.
8.3.3 Function keys
The function keys are is used to view settings, access a menu (shortcut) or start a direct action.
An enabled function key is available in the function keys bar (see chapter “Function keys bar”).
Access: Menu [Configuration] [Function keys]
Choice - Setting limit
1)
Timer
Audio
Cor.
Mute
Reject point
Infor.
Tracer gas
Vent
Method
Mode
Memo
Paging
Regen
Cal type
Screen Shot
Switch Set point
Enable for each function key
Function key display in the function keys bar
16 function keys are offered but only a maximum of 15 can be made availa-
ble (enabled) in the function keys bar. The 16
th
function key is greyed out. To
enable it, disable another function key first.
Enabled
Disabled
1) Initial setting: see chapter “Tree diagram to the Settings menu”
8.3.4 Screen settings
This menu is used to enter the control panel settings.
Access: Menu [Configuration] [Screen settings] Choice - Set-
ting limit
1)
Brightness To be set 0 – 20
Paging Function Function available only if a wireless remote control is detected.
To be selected
When a wireless remote control (accessory) is used, the ’Paging’ function makes it
possible to easily find the remote if it is located within its field of use with the detector.
When the function is activated, the remote control emits a sound signal so it can be
located. To stop the sound signal, deselect the Paging function.
Function key: see below.
Enabled
Disabled
1) Initial setting: see chapter “Tree diagram to the Settings menu”
Settings menu
62/98
To Next Page
Loading...
